When I try to move a circuit from one sheet to the other using cut/paste, it loses all the connection that were done without wires. Is there a way around this? I have many connections done this way. At least in my opinion there is no good reason connections without wire are lost while all others are kept.

Similar issue with copy/paste - the new circuit loses all connections without wires and all named connections. But usually most of these connections are perfectly fine and it's very cumbersome (and error-prone!) to re-create them every time. Just think of e.g. several devices on a bus - clearly a want ALL of them to be connected to the same address, data and clock lines to the master, at best the chip enable changes. Right now I haven't found a good way to do this...

I see the issue. Thank you for the report, we will try to fix it in future.