Search found 7 matches

by jet31
03 Mar 2017, 22:59
Forum: PCB Manufacturing Questions
Topic: What is the Formula to Calculate the Cost Of PCB Fabrication
Replies: 8
Views: 8418

Re: What is the Formula to Calculate the Cost Of PCB Fabrica

just send your PCB design to FAB house and fill up some form
then they will send you the quotation of your PCB.
by jet31
03 Mar 2017, 22:44
Forum: Basic Schematic and PCB Design
Topic: Nets have merged by accident and I can't separate them
Replies: 7
Views: 4748

Re: Nets have merged by accident and I can't separate them

In my first encounter of DipTrace this also happen to me , where my gnd and my Vcc ara accidentally connected. It was a big miss coz there a lot of component connected to the two signal. This is something that DipTrace should also correct. But I found a way in order this thing not to happen again in...
by jet31
03 Mar 2017, 20:16
Forum: Bug reports
Topic: Copper Pour Line Width: 0.1mm (smallest size)
Replies: 2
Views: 2114

Re: Copper Pour Line Width: 0.1mm (smallest size)

Right now our tracks are usually 0.1mm routing, sometimes we go 0.08 mm in special cases.. Is there a change that the Copper Pour line width could go just a little bit lower than 0.1mm to cater our scenario. Im my previous PCB tools (Circad Omniglyph). My usual Copper Pour line width is 0.06mm to so...
by jet31
03 Mar 2017, 06:28
Forum: Other questions and issues
Topic: Top Silk Text rotating
Replies: 1
Views: 2306

Top Silk Text rotating

Hello DipTrace, We have this problem that the TopSilk text will rotate when we block rotate the whole PCB. We already arrange the text in its proper place away form pads and holes so that it will not be a miss-up thing. but when we rotate the whole PCB the text well also rotate back agains the PCB d...
by jet31
03 Mar 2017, 05:51
Forum: Bug reports
Topic: Copper Pour Line Width: 0.1mm (smallest size)
Replies: 2
Views: 2114

Copper Pour Line Width: 0.1mm (smallest size)

Hello DipTrace , We have experience that the smallest Line Width is only 0.1mm. We are making a small size PCB with small component like 0201 resistor and capacitor. Our problem is that when using a 0.1mm Line Width during Copper Pour, some gnd with thermal setting cannot be connected. The copper po...
by jet31
03 Mar 2017, 05:15
Forum: Shared 3D models
Topic: Easy browse, search, preview for the DipTrace 3d Models
Replies: 7
Views: 15801

Re: Easy browse, search, preview for the DipTrace 3d Models

This is a great job.

I have the same problem when I first use Diptrace. finding the right 3D model for my component.
What I did is that I draw my own 3D parts.
by jet31
03 Mar 2017, 01:55
Forum: Shared 3D models
Topic: 3D CAD software recommendations?
Replies: 13
Views: 22914

Re: 3D CAD software recommendations?

Hi guys,

I use Solidwork to make my 3d model component. it is very easy to learn.

if you have some 3d drawing to make maybe i could help.

thanks,
jet,