I just found this post and tried this for update from 4.2 > 4.3 and it works. Thanks!

Congrats on the new update! I noticed if I file > open > any network file I get an error "T:\xxxx is unavailable" Also if I go My computer all network drives are not showing, if I navigate with file explorer and open the file it works no problem This may not be a diptrace error but was working on la...

Hi All,

This is a note to myself and anyone else that may be searching for this.
If you're net is missing from the "add to net" list, it may be because the net is locked

To fix unlock net DOH!

This worked for me, I had an snapEDA imported CR2032 holder that I need to hang out over the edge of the PCB so need to cut down pad under the battery to fit within the board outline

Thanks Tom

Map VA.png Hi Tomg, Thank you for your help. For completeness This worked very well and save me a lot of time and sanity :D The only gripe I have is there was no way of generating a net list ect but I understand why. So I had route all traces manually it's a shame the Vdd and Vss could not be attac...

Hi Tomg,

Genius! I will try it out and report back

Hi All, I have a layout job that is pretty daunting coming up, let me paint a picture! 754 leds in a radiating circular pattern generated in solidworks see attached pic Now I do not want to have to place each part manually it will take longer than I have. I have been looking at exporting XY point da...

Hi Alex,

You were right that worked a treat
Must have been something to do with using different computers

Thanks!

We have been updating a PCB design, when opening the layout lots of clearance errors have come up that was not there before, the DRC is finding faults eg gap=0.25 rule=0.3 but when I look at the DRC settings they are set at 0.13. Reloading the DRC settings does not clear the errors

Any ideas?

Just comming across this now and am dissapointed that it has no implementation on V3.3.13 :cry: I think the nickname is a dogbone. We will make a pattern that is wide and short then a componant with two pins and connect the pins together in pattern with a blue line This will enable layout to not err...