Thank you so much, Tom. This works now!
Always a pleasure getting support from you.
O

Hi Tom,

I tried applying to current pad to no avail. I set mask to 'open' and paste to 'no solder' in layout editor, saved it then went to PCB editor and on my board I dropped in this touch sensor pad with new settings but mask (in blue outline) is still there. I was going to post images of the ...

Hi Tom,

Thanks for the prompt response. However, you did not answer my question. I need to know if there's a way to remove the solder mask from a single pin pad in layout editor. So far, I tried everything and no method allows for the removal of solder mask from a pad geometry.

Appreciate the ...

Hi All,

I am trying to create a touch sense pad which needs to have the pad fully covered in resist (no solder mask around it) but Diptrace doesn't give me any options to remove solder mask during the creation of such touch sense pad in the pattern editor (single pin pad - rectangle). I tried right ...

Hi TomG
Thanks for posting. This has answered my question.
O