Page 1 of 1

Units between DT applications

Posted: 24 Dec 2019, 13:24
by KevinA
I had to add some patterns (everything below 0402) and discovered since moving to my new computer the Pattern editor has lost it's mind. I added mm units in PCB Editor based on using this product in metric mode NOT imperial as in Grid 2.45mm - What I end up doing is adding everything from 5mm to .005mm with all the steps between. I did add it to the PCB Layout, why didn't Pattern editor pick it up?

Re: Units between DT applications

Posted: 27 Nov 2020, 03:53
by Alex
Units and grids settings are specific for each machine where DipTrace installed. If you move to different computer you can edit grids using "View -> Customize Grids" in PCB Layout or Pattern Editor. In regards to units you can change them using View -> Units or Shift+U.