Making PC Board Only

DIY Projects and Methodologies, Hobby Circuits, Circuit Samples
Post Reply
Message
Author
nottus
Posts: 2
Joined: 28 Feb 2016, 18:25

Making PC Board Only

#1 Post by nottus » 28 Feb 2016, 18:43

I was able to make one board using a 8 pin dip and a 18 pin dip. I found the dips on the left side, since, I am unable to find them again??

Attached is what I am making for my xmitter and want to make a rec. for it.

Thanks
You do not have the required permissions to view the files attached to this post.

MDman
Posts: 43
Joined: 26 Oct 2011, 02:53

Re: Making PC Board Only

#2 Post by MDman » 29 Feb 2016, 02:58

To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.

nottus
Posts: 2
Joined: 28 Feb 2016, 18:25

Re: Making PC Board Only

#3 Post by nottus » 29 Feb 2016, 13:28

MDman wrote:To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.

I tried this, as you said, to no avail. Very strange.

I am using the "free" software. Seems the software is "buggy"? Or I am.

Thanks

farley
Posts: 124
Joined: 15 Sep 2011, 16:28

Re: Making PC Board Only

#4 Post by farley » 29 Feb 2016, 16:43

Have you perhaps moved or removed any of the pattern libraries?

This is from DipTrace ver. 2.4.0.2:
diptrace_patterns.jpg
You do not have the required permissions to view the files attached to this post.

Techno Tronix
Posts: 188
Joined: 10 Jan 2015, 02:00
Location: Anaheim, CA 92806
Contact:

Re: Making PC Board Only

#5 Post by Techno Tronix » 20 Jul 2016, 02:46

nottus wrote:
MDman wrote:To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.

I tried this, as you said, to no avail. Very strange.

I am using the "free" software. Seems the software is "buggy"? Or I am.

Thanks
Which "free" software you are using?

Post Reply