I was able to make one board using a 8 pin dip and a 18 pin dip. I found the dips on the left side, since, I am unable to find them again??
Attached is what I am making for my xmitter and want to make a rec. for it.
Thanks
Making PC Board Only
Making PC Board Only
- Attachments
-
- HT-12 XMITTER.dip
- (22.43 KiB) Downloaded 203 times
Re: Making PC Board Only
To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.
Re: Making PC Board Only
MDman wrote:To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.
I tried this, as you said, to no avail. Very strange.
I am using the "free" software. Seems the software is "buggy"? Or I am.
Thanks
Re: Making PC Board Only
Have you perhaps moved or removed any of the pattern libraries?
This is from DipTrace ver. 2.4.0.2:
This is from DipTrace ver. 2.4.0.2:
-
- Posts: 188
- Joined: 09 Jan 2015, 19:00
- Location: Anaheim, CA 92806
- Contact:
Re: Making PC Board Only
Which "free" software you are using?nottus wrote:MDman wrote:To find the Dip patterns, depending what version of DT your running, click on "filter off" Then search area "all libraries", name "Dip".
Alternately at the top of your library viewing window, click to select which library you would like to use and select "patterns".
Then select "general" or "dip" and you will find the dip patterns there.
I tried this, as you said, to no avail. Very strange.
I am using the "free" software. Seems the software is "buggy"? Or I am.
Thanks