Page 1 of 1

How to divide the scheme on two pcb plates?

Posted: 08 Jun 2017, 08:59
by AlexTitov
My scheme is a controller with high-load transistors. I would like put the control part on the one PCB, and the power part on another PCB. What is the best way to do that?
I tried to put my scheme onto two sheets in Schematics and used bus connectors between sheets. But all these go onto single PCB anyway.

I realize that I can divide the scheme into two separate projects. But I hope to export my scheme into some simulator some later so it should be single complete scheme for that.

Re: How to divide the scheme on two pcb plates?

Posted: 23 Aug 2017, 05:37
by Love life
Then you can design two schematics. One is the control module circuit, one is the power module circuit.
Then use the cable link.