Page 1 of 1

Custom design

Posted: 24 Aug 2018, 03:16
by pcbgogo_dph
Custom design, for a legacy application requiring unusually low audio distortion and audio intermodulation, combined with exemplary RF performance parameters. The Pilgrim receiver is a multichannel (single loop synthesizer) design incorporating a triple conversion architecture, with an unusual low frequency PLL demodulator. Switching mixers are used throughout the signal path to ensure good large signal handling. : The board was made, and the surface mount assembly done, by PCBgogo.

My project photo

Re: Custom design

Posted: 28 Aug 2018, 16:37
by RushPCB.Com
I was wondering, whether you are providing any worth information or looking for any answers..

Re: Custom design

Posted: 13 Sep 2018, 21:39
by pcbgogo_dph
RushPCB.Com wrote:
28 Aug 2018, 16:37
I was wondering, whether you are providing any worth information or looking for any answers..
Hello,If you have any relevant requirements for the PCB, you can find PCBGOGO, from design to patch to production, to meet all your requirements.They are doing some activities,send free coupons, a PCB board is very cheap.

Re: Custom design

Posted: 21 Apr 2020, 08:07
by mokosmart
I think it’s cheap, it’s fun to watch, but you can try it before I bought it at mokoPCB.