I have an alert when I try to autoroute with a STM32F103CBT6 (ARM microcontroller - package LQFP-48).
Alert
I use standard parameters.
Now I can't route the pins of the ARM:
https://s33.postimg.cc/hswax0yrj/Bildsc ... .08.28.png
I know I'll have to tweak manually the routing after, but please, what do I need exactly to change (which menu) reduce trace width/clearance so that I can start to autoroute all pins of the ARM?
https://s33.postimg.cc/63sb932nz/Bildsc ... .08.51.png
Reduce trace width/clearance routing alert
Re: Reduce trace width/clearance routing alert
In the Main Menu click on "Route" and then choose "Route Setup..." in the drop-down menu to bring up the Route Setup dialog window. In the Route Setup dialog window select the [Traces and Vias] tab and play around with the settings circled in the illustration below to see if that helps...
Tom
Re: Reduce trace width/clearance routing alert
Awesome. You just saved me!!!
Works fine. THANK YOU.
Works fine. THANK YOU.
Re: Reduce trace width/clearance routing alert
Oh. Bummer. I saved the file. then all crashed. First time it does (OS X).
Now when I try to open the file: "File unpacking exception. Probably the file is corrupted."
And the file is empty.
0 bytes.
That's hard.
Of course this happens while I did not backup since I created this.
Aaargh...
Now when I try to open the file: "File unpacking exception. Probably the file is corrupted."
And the file is empty.
0 bytes.
That's hard.
Of course this happens while I did not backup since I created this.
Aaargh...