Hi all,
I have a PCB where a component (connector) is placed at an irregular angle (say 30 degrees), and I would like to make the traces reach the component at that angle, instead of 90deg or 45deg.
Is this possible? If yes, then how do I set the angle?
Thanks in advance,
Noam
Irregular angle for trace placement
Re: Irregular angle for trace placement
Yes.
You will have to eyeball it, but using the "Free Line" routing mode should get you close to what you want...
You will have to eyeball it, but using the "Free Line" routing mode should get you close to what you want...
Tom