Page 13 of 13

Re: DipTrace Team has the question to our users

Posted: 04 Jun 2021, 08:04
by Batiskaff
Bob Innes wrote:
28 May 2021, 15:00
Have to produce a 2-layer PCB with the Top layer Silkscreen, Bottom copper tracks, and pour. Firstly Diptrace says that the bottom color must be a reduced color opposed to the top color. Mine are the reverse way around - how do I change this? I am new to using Gerber files, looking through from the top side, the bottom layer looks the same. Do I assume that the Greber file for the bottom layer must NOT be "Mirrored" am I correct? Only text on the bottom must show through in a reversed mode.
I am 83 years old and have a problem understanding the technique of Gerber files.
An answer is here: viewtopic.php?f=4&t=14092

Re: DipTrace Team has the question to our users

Posted: 17 Aug 2021, 12:45
by dmatkin
JLCPCB library would be nice. Especially if it was done up to include their LCSC part numbers. Even a partial one would potentially be really nice for populating cheaper boards with some PCBA.