On some tracks, tinning has been added (mask removed) to make the track thicker.
In previous versions, this was an object that could be removed, moved and so on.
Now the tinning is not visible. How then to find it (the project is old, was created and saved in version 3) and how to delete at least?
I moved the traces from the old location, but the tinned mask remains in the same place (visible as a blue board)
For general questions regarding the software and for all questions that do not fit in any of the threads above.
2 posts • Page 1 of 1
Temporarily change the Layer Display Mode to "Current Only", select the appropriate Current Signal/Plane Layer, turn off its copper (Top or Bottom) and make sure its Mask layer is enabled so you can see all of the Mask openings.