When I uploaded Version 3.3.0.0 , all appeared to go well.
Approximately a week later, I received an online invitation to upload Ver. 3.3.0.1 .
I found this strange after only 1 week. Unfortunately, Ver3.3.0.1 erased my personal library of parts, of which
I have created several dozen custom parts that I use on my PCB's. Is this my fault ? I am now trying to find an uptodate
copy of my personal library somewhere on my system.
What was the reason behind Ver. 3.3.0.1 ??? ( other than to destroy private libraries) ?
Diptrace 3.3.0.1
Re: Diptrace 3.3.0.1
We fixed few bugs in build 3.3.0.1.
If you saved custom libraries in DipTrace folder new installation might delete them. We recommend to save custom libraries in other than C:\Program Files\DipTrace\ folder.
If you saved custom libraries in DipTrace folder new installation might delete them. We recommend to save custom libraries in other than C:\Program Files\DipTrace\ folder.
Re: Diptrace 3.3.0.1
This is a post about an alternate library setup with archiving and version-control.
viewtopic.php?f=5&t=11914&p=23484#p23484
Currently there is no means to use any version control with DipTrace nor is there a means to export a project with all the support files needed to actively update or a multi-user setup.
An intergraded GIT feature would be a welcome add-on along with a 'Project' export...
viewtopic.php?f=5&t=11914&p=23484#p23484
Currently there is no means to use any version control with DipTrace nor is there a means to export a project with all the support files needed to actively update or a multi-user setup.
An intergraded GIT feature would be a welcome add-on along with a 'Project' export...