Placed component is different from library

For general questions regarding the software and for all questions that do not fit in any of the threads above.
Post Reply
Message
Author
sinking
Posts: 1
Joined: 28 Jan 2021, 20:45

Placed component is different from library

#1 Post by sinking » 28 Jan 2021, 20:52

I've been doing simple designs with Diptrace for a few years and getting moderately comfortable and gone through PCB fabrication quite successfully.

Just noticed an issue with my latest board, where the placed component in PCB layout is different from what I see in the component editor. It's a MOSFET that I imported using Library Loader and the Component Editor view matches the datasheet.
Screenshot (197).png
Screenshot (197).png (118.7 KiB) Viewed 158 times
But, for reasons unknown, when I place the component into my design (even a blank new one), the drain/source pins get swapped:
bss138pw component.png
bss138pw component.png (55.95 KiB) Viewed 158 times
What would cause this?

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: Placed component is different from library

#2 Post by Alex » 08 Feb 2021, 03:04

Please upload the library and I will verify it.

Post Reply