Schematic Print thickness is thin !

Drawing Schematics, Hierarchical Design, BOM, Exporting net-lists, etc.
Post Reply
Message
Author
clickshe
Posts: 1
Joined: 04 Mar 2017, 10:43

Schematic Print thickness is thin !

#1 Post by clickshe » 21 Mar 2017, 12:13

Hello
I tried to print schematics, but the thickness is very thin !
Yes, I know that i can increase the thickness from View/Line Width, but if I increase from there:
1 - the component symbols will remain thin
2- the line width will be fat.

Do not tell me that I have to change the thickness to all symbols, because it would be absurd !
Comparing the DipTrace prints with those made with other similar software, those of DipTrace
have a very ugly appearance, and, above all, they are very difficult to read in detail.

Is there a solution that I missed?
Thank you for reading.

Post Reply