All I'm trying to do is connect one bus (with 8 nets) to another page.
The bus on the first page ('first' being what I drew out first) has a green connector dot, whohoo. It's not boxed, though, as it's the only bus label/connector on that page.
Go to the second page, create the bus with bus connector. It gets a green dot, and the name is boxed. Double whohoo. Go to connect a net up and... there are no nets! If I enter in the name of a net that exists on the bus on page 1, but then I get a message saying that net exists on another page.
Doing searches, I see references to Hierarchy pages. In the situation above, both pages were 'Normal'. Changing either page to 'Hierarchy Block' will remove the box, but still no nets will be there.
What am I missing? It can't be this difficult or convoluted to run nets/bus to other pages, so I think I'm missing something.
