Page 1 of 1

Lost linebreaks after reading .asc file back into DipTrace

Posted: 14 Jan 2018, 10:59
by Hansel
Procedure:
1. Create one or more tables with 1x1 cell for multi-line text. Use linebreaks (hit "enter").
2. Write the schematic out as DipTrace ASCII (.asc) file.
3. Read that file back into DipTrace -- All linebreaks are lost.

Re: Lost linebreaks after reading .asc file back into DipTrace

Posted: 15 Jan 2018, 10:05
by Alex
I confirm the issue, thank you for the report. We will fix it in the next version.

Re: Lost linebreaks after reading .asc file back into DipTrace

Posted: 15 Jan 2018, 12:52
by Hansel
Hi Alex, thanks for the confirmation. While fixing this issue, would you also look into allowing empty lines in the multi-line entries? Right now, empty lines are removed in the PCB editor (tables). That makes formatting text nicely easier.Thanks.