Moving Custom Component in Schematic

Drawing Schematics, Hierarchical Design, BOM, Exporting net-lists, etc.
Post Reply
Message
Author
meidinad
Posts: 2
Joined: 04 Dec 2021, 15:36

Moving Custom Component in Schematic

#1 Post by meidinad » 04 Dec 2021, 16:21

Hey all,

I have created a few custom components. Now, when trying to use them in schematic capture, I can't move them. I've noticed that other components, when hovering over them they turn blue and a hand appears that allows you to move them. This isn't the case with my custom components.
One of them is a switch with 9 pins - if that helps.

They seem to work perfectly aside from this.

Has anyone encountered this and may have a fix?
Thanks!

Alex
Technical Support
Posts: 3894
Joined: 13 Jun 2010, 23:43

Re: Moving Custom Component in Schematic

#2 Post by Alex » 05 Dec 2021, 23:03

Could you please send the schematic to DipTrace support or upload on the forum for verification?

Post Reply