Replace Part only works for part 1 of multi-part component

Drawing Schematics, Hierarchical Design, BOM, Exporting net-lists, etc.
Post Reply
Message
Author
plingane
Posts: 3
Joined: 30 Nov 2021, 08:07

Replace Part only works for part 1 of multi-part component

#1 Post by plingane » 27 Dec 2021, 08:05

I wish to change to a different package of a multi-part component already on my schematic. I right-clicked on Part 1, chose Replace Part..., and successfully changed Part 1 to the new part number which it found in your library. Then I tried to do that again with Part 2 and also with Vcc & GND, but the Replace Part dialog box only shows me the image for Part 1 and wants to make Part 2 have the same pinout as Part 1. See screenshot attached, where on the schematic I have selected Part 2 (U1.1) but the dialog box image only shows Part 1 even though the drop down menu shows Part 2.
Is this a bug or am I missing something?
Thanks!
Paul
Screen Shot 2021-12-27 at 10.33.45 AM.png
Screen Shot 2021-12-27 at 10.33.45 AM.png (277.65 KiB) Viewed 269 times

Post Reply