Page 1 of 1

No connects

Posted: 21 Nov 2010, 19:53
by zbrosdad
Is there a way of marking non-used or no-connect pins so that you don't get an error when running the design rule check?

Re: No connects

Posted: 22 Nov 2010, 07:58
by Alex
Hi,
Please open "Verification/ Electrical Rule Setup" from main menu in Schematic. Unselect "Not Connected" option from list of rules. After that, you won't get ERC errors if there are non-used or non-connected pins in your schematic.

Re: No connects

Posted: 22 Nov 2010, 10:46
by zbrosdad
Yes, this will work but it will also obscure real errors and that makes the error check close to worthless.

Re: No connects

Posted: 23 Nov 2010, 05:29
by Alex
Well, don't unselect this option in that case. You can right click on pins in schematic and set "Not Connected" option for them.