Multi-Section Part

Drawing Schematics, Hierarchical Design, BOM, Exporting net-lists, etc.
Post Reply
Message
Author
richas
Posts: 21
Joined: 05 Mar 2012, 18:13

Multi-Section Part

#1 Post by richas » 07 Mar 2012, 19:52

I am creating and FPGA device, pattern and component.

I want to have it divided up into sections. So I drew (In Component Editor) several boxes and arranged various pins around them.

This seemed fine until I tried to use it in a schematic. All the sections (boxes) are part of the same device and I cannot run wires across it etc.

I tried using the multi-part method explained in the tutorial but that seems to be for creating identical sections only...


Rich

novarm44
Technical Support
Posts: 388
Joined: 09 Jun 2010, 06:24
Contact:

Re: Multi-Section Part

#2 Post by novarm44 » 08 Mar 2012, 11:37

See Component/Add New Part in component editor and select parts in the lower-left.
Also you can see step-by-step instruction how to create multi-part component in PDF tutorial (Component Library).

richas
Posts: 21
Joined: 05 Mar 2012, 18:13

Re: Multi-Section Part

#3 Post by richas » 09 Mar 2012, 13:47

novarm44 wrote:See Component/Add New Part in component editor and select parts in the lower-left.
Also you can see step-by-step instruction how to create multi-part component in PDF tutorial (Component Library).

Thanks for the help!

Post Reply