Is there a way to scale the schematic image of a part? The size at which the part's schematic library icon is drawn is of course arbitrary, and sometimes a schematic with only a few parts on it is easier to read if one or more of the parts is just drawn larger. Being able to enlarge some parts would be especially valuable when a schematic will be used in printed form, without convenient means of zooming.
To keep the pins lined up with the grid, scaling would need to be limited to integral multiples of the drawn-at scale, but with that limitation it might be easy to implement.
scaling parts during or after schematic placement
Re: scaling parts during or after schematic placement
It is not possible to scale a component in Schematic. We will consider this option, but it won't be implemented in near future.
Re: scaling parts during or after schematic placement
Ten years later, I could use it too. I need to shrink a part or redraw it.
-
- Posts: 4
- Joined: 11 May 2021, 01:54
Re: scaling parts during or after schematic placement
Since years, I need also this feature...
Is it any hope to get it?
Is it any hope to get it?
Re: scaling parts during or after schematic placement
I will up the feature request, thank you.