Hi,
In Schematics there is a possibility to set which side a specific component shall be placed.
Component properties>Attached pattern>Side>Top or Bottom
I have tried to change a SOIC-20/300mm pattern to bottom instead of top side.
But in PCB layout it remain on the top side and I have to make the change inside PCB instead.
Why ?
Am I missing something here ?
BR/Nissbola
Correct board side from Schematics ?
Correct board side from Schematics ?
BR/Nissebola
Re: Correct board side from Schematics ?
There is no way to predefine what side a specific component will be placed. The setting in Schematic editor allows only to preview patterns from different sides.