Page 1 of 1

European component symbols

Posted: 28 Dec 2012, 15:07
by mrbyte
Hi,

Really enjoying using DipTrace. I think it is excellent, but all the resistor symbols in the discrete library are American style. How can I change these to European symbols?

Also, there are a lot of different types of resistors, how do I know what size the footprint is of the one I have chosen (through-hole)?

Thanks! :mrgreen:

Re: European component symbols

Posted: 29 Dec 2012, 06:21
by John77
I made my own library of european symbols. Its quite easy to do with the Diptrace component editor. Give it a try.

Through hole resistor sizes are in the name. ie. RES400 = 400mil hole centres on the pcb.

Regards
John

Re: European component symbols

Posted: 29 Dec 2012, 08:21
by Alex
We added library with European symbols in version 2.3. It was called "EuroSym".

Re: European component symbols

Posted: 29 Dec 2012, 14:59
by mrbyte
Thanks for clearing up the size issue, I see what you mean now :)

I suppose I can just clone the discrete library and change the symbols to European style from the library EuroSym. It would be nice if the EuroSym library had all the components already done like it is already with American style symbols (with different footprint patterns for sizes) though, not a huge issue but it would be nice. The previous schematic software I used that had two libraries that had the same components but with different style symbols.

Thanks again

Re: European component symbols

Posted: 04 Jun 2020, 10:45
by poll western
Alex wrote:
29 Dec 2012, 08:21
We added library with European symbols in version 2.3. It was called "EuroSym".
I tried the 4.0,0,2 version and no found European symbols anywhere
Where is this library so we can add it to the diptrace

Re: European component symbols

Posted: 04 Jun 2020, 12:07
by Tomg
Look for the component library named "Objects Symbols EIC" near the end of the libraries list.