How do I delete a ratline

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Message
Author
bogdan546
Posts: 10
Joined: 09 Nov 2014, 23:10

Re: How do I delete a ratline

#11 Post by bogdan546 » 20 Oct 2021, 15:39

I succeeded. Thank You

TDHofstetter
Posts: 2
Joined: 09 Jun 2022, 05:07

Re: How do I delete a ratline

#12 Post by TDHofstetter » 09 Jun 2022, 06:26

I'll verify ... that works. I just ran into exactly the same problem and it was completely unintuitive to draw another ratline on top of the unwanted one to delete it, but it does work.

It'd be much better if DipTrace didn't automatically add ratlines when you delete traces, though! Then we'd have no ratlines to remove by duplication.

Serg
Technical Support
Posts: 519
Joined: 09 Jun 2010, 01:12

Re: How do I delete a ratline

#13 Post by Serg » 09 Jun 2022, 21:14

TDHofstetter wrote: 09 Jun 2022, 06:26 I'll verify ... that works. I just ran into exactly the same problem and it was completely unintuitive to draw another ratline on top of the unwanted one to delete it, but it does work.

It'd be much better if DipTrace didn't automatically add ratlines when you delete traces, though! Then we'd have no ratlines to remove by duplication.
There is an option in the main menu "Route - Route Setup - Settings - Remove Ratline while Deleting Trace".
Use it to delete the ratline after deleting a trace.

Screenshot.png
Screenshot.png (35.17 KiB) Viewed 245 times

Post Reply