Create a snap apart board?

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
grimepoch
Posts: 4
Joined: 15 Aug 2014, 14:58

Create a snap apart board?

#1 Post by grimepoch » 05 Sep 2014, 12:11

Hello!

I have a board that I optionally want to make smaller by having a section I can snap off if I need to. What is the best way of doing this? I was thinking of making an array of drill holes, but then I thought, maybe there is a more standardized way of doing this.

I will not have any traces going through these areas.

KOBE_13
Posts: 65
Joined: 15 May 2011, 11:46

Re: Create a snap apart board?

#2 Post by KOBE_13 » 06 Sep 2014, 07:41

I have done as shown below... have also seen what is called a V-score.

You do not have the required permissions to view the files attached to this post.

Post Reply