revision compatability?

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
doc
Posts: 15
Joined: 16 Nov 2017, 22:37

revision compatability?

#1 Post by doc » 19 Nov 2017, 14:57

i can't open version 1.5 pcb layout files with latest revision.
should i be able to?
if i buy upgrade, will it load to separate folder so i keep both versions?

another problem, after i convert schematic to pcb, the pcb program will not close. have to reboot to close it.
and it doesn't show my other files until i close. this is in 1.5 version.
thanks

Serg
Technical Support
Posts: 410
Joined: 09 Jun 2010, 08:12

Re: revision compatability?

#2 Post by Serg » 20 Nov 2017, 08:21

1) The latest version DipTrace should open all designs which created in older versions. Please, send the files to support:
support at diptrace.com
2) You can preset a directory while installing process. It is possible to use several DipTerce versions which did installed on the different places. But we recommend to install and use only one version.
3) Try to install 1.5 on another disk.

Post Reply