Page 1 of 1

Why does export to Gerber shift the origin ?

Posted: 07 Sep 2019, 18:21
by NewtownGal
I'm a newbie to DipTrace. I'm having a problem exporting a pcb layout to Gerber.

I've designed a simple test board that is 1.6" square. I've put a 1" dia cutout in the middle of it. The origin is where one would expect, at the lower left hand corner of the board. But when I export to Gerber, and click Preview, the origin has moved 1 cm down and to the left. And sure enough, when I export the board outline and view it in any online Gerber Viewer, the board design has shifted.

Why is it shifting and how do I avoid it ?

Thank you in advance.

Re: Why does export to Gerber shift the origin ?

Posted: 09 Sep 2019, 15:47
by MPman859
Diptrace has the option to export PCB designs with an Offset. You can have your gerbers use a different origin than your original design file. That is useful for some, but not others.

In your case, I would simply check the "Use Design Origin" (in the Gerber export menu, right above "Export" and "Export All" buttons).

Re: Why does export to Gerber shift the origin ?

Posted: 09 Sep 2019, 16:30
by NewtownGal
That solves it. Thank you. Don't know why there was an offset of 1 cm in both x and y.