Hi, I've been using diptrace for a little while and really like it but im starting to do more tricky things. I would like to know how you do custom routing (milling) of a hole (like in the example below). The manufacturer has made a hole for a rf mosfet and they've made little inserts which cutout inside. The parts that cutout, fit onto the ends of a pignose ferrite and make a 9 to 1 transformer which goes onto the pcb just to the left of the mosfet hole. There is an example of this infront of the pcb.
I need to do the same, is it possible to do with diptrace?
Custom hole cutting for mosfets?
Custom hole cutting for mosfets?
You do not have the required permissions to view the files attached to this post.
Re: Custom hole cutting for mosfets?
Draw the required slot(s)/cutout(s) on the Board Cutout layer. Here is an example of how one PCB manufacturer would like to see slots/cutouts defined - https://www.eurocircuits.com/blog/slots-and-cut-outs/. Other board houses might have different requirements.
Tom
Re: Custom hole cutting for mosfets?
Thanks, I managed it, hopefully pcb house will be ok with it 

You do not have the required permissions to view the files attached to this post.