copper pour problems

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
radivoje
Posts: 1
Joined: 01 Oct 2019, 15:17

copper pour problems

#1 Post by radivoje » 01 Oct 2019, 15:22

Hello,
I have existing PCB designed/verified/made in older version of DipTrace (not sure the version that was created with). I am modifying the design to accommodate new requirement. However, after I run Autorouter I am getting several messages in regards to copper pour such as:
Drill - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Via_336 - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Pretty much I cannot add any new Via's without these errors showing up.
What can be done to resolve these?
Thanks

Alex
Technical Support
Posts: 3129
Joined: 14 Jun 2010, 06:43

Re: copper pour problems

#2 Post by Alex » 02 Oct 2019, 05:05

Obviously, there are short circuits between copper pour and the drill and via_336. Please update copper pour (Objects -> Update All Copper Pours) and that should resolve the errors.

Post Reply