Page 1 of 1

copper pour problems

Posted: 01 Oct 2019, 15:22
by radivoje
Hello,
I have existing PCB designed/verified/made in older version of DipTrace (not sure the version that was created with). I am modifying the design to accommodate new requirement. However, after I run Autorouter I am getting several messages in regards to copper pour such as:
Drill - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Via_336 - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Pretty much I cannot add any new Via's without these errors showing up.
What can be done to resolve these?
Thanks

Re: copper pour problems

Posted: 02 Oct 2019, 05:05
by Alex
Obviously, there are short circuits between copper pour and the drill and via_336. Please update copper pour (Objects -> Update All Copper Pours) and that should resolve the errors.