I have encountered a problem I have never encountered before. I have two jacks on a board and the copper pour is touching the pads. Its never happened before. All other pads are separated from the pour bet these.
Can anyone assist with this issue? Anyone seen it before?
Cheers
Copper pour not working on one design
-
- Posts: 2
- Joined: 08 Jun 2020, 11:32
Copper pour not working on one design
- Attachments
-
- Copper pour issue.JPG (37.13 KiB) Viewed 117 times
Re: Copper pour not working on one design
Please right click on the pad and open "Thermal Settings". If custom settings are used please make sure the connect option is set by pour.
-
- Posts: 2
- Joined: 08 Jun 2020, 11:32
Re: Copper pour not working on one design
Figured it out. ... I had bottom layer set as plane, not signal. As soon as I changed it, it all worked.