We have been updating a PCB design, when opening the layout lots of clearance errors have come up that was not there before, the DRC is finding faults eg gap=0.25 rule=0.3 but when I look at the DRC settings they are set at 0.13. Reloading the DRC settings does not clear the errors
Any ideas?
DRC error issue
DRC error issue
- Attachments
-
- drc.jpg (80.02 KiB) Viewed 203 times
Re: DRC error issue
Please open net class properties. If "Use clearance in DRC" is enabled then net class rules will be applied for the net class instead default DRC rules.
Re: DRC error issue
Hi Alex,
You were right that worked a treat
Must have been something to do with using different computers
Thanks!
You were right that worked a treat
Must have been something to do with using different computers
Thanks!