Hello
I was wondering why a route keep out on, say, the top layer shows up as blank squares on the inner layers. For whatever reason it does not happen with the bottom layer.
I'm not sure what the purpose of this was but I don't remember this being the case in earlier versions. The problem is that it makes it look like the metal is missing on these layers when in fact if you look at the gerbers (for example) these blank areas do not show up. it is very misleading so I don't see the necessity of this.
Thanks for any info you can give.
jom
Route Keepout Question
Re: Route Keepout Question
Route Keepout visibility is dependent upon the "Layer Display Mode" setting...
* When set to "Current Only", Route Keepout will not be visible on other layers.
* When set to "All Layers", Route Keepout will be visible on all layers.
* When set to "Contrast", Route Keepout visibility on the other layers will be subject to the "Contrast Level" setting.
A copper pour will also affect Route Keepout visibility on other layers.
* When set to "Current Only", Route Keepout will not be visible on other layers.
* When set to "All Layers", Route Keepout will be visible on all layers.
* When set to "Contrast", Route Keepout visibility on the other layers will be subject to the "Contrast Level" setting.
A copper pour will also affect Route Keepout visibility on other layers.
Tom
Re: Route Keepout Question
Thanks for that! Much appreciated.
jom
jom