ODB++ Bug

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
matttay
Posts: 62
Joined: 07 Aug 2010, 18:58

ODB++ Bug

#1 Post by matttay » 17 Aug 2022, 05:52

Attached PCB generates correctly for gerber, but incorrectly for ODB++.

In the attached picture, you can see the exported gerber is correct. But the ODB++ is not correct.
Diptrace odb++ Bug.jpg
Diptrace odb++ Bug.jpg (123.59 KiB) Viewed 558 times
The PCB file for this is attached. The issue is this: When layer 3 is defined as signal the ODB++ result is correct. When layer 3 is defined as plane, Diptrace handles it correctly, but the generated ODB++ has severe design rule violation.
Attachments
PCB.dip
(19.67 KiB) Downloaded 59 times

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: ODB++ Bug

#2 Post by Alex » 21 Aug 2022, 23:52

Thank you for the bug report, we will investigate the problem.

Alex
Technical Support
Posts: 3897
Joined: 13 Jun 2010, 23:43

Re: ODB++ Bug

#3 Post by Alex » 23 Aug 2022, 23:20

We have fixed the bug under source codes. See attached odb++ archive where the problem has fixed. The next build will include the fix.
Attachments
pcb.zip
(48.25 KiB) Downloaded 78 times

matttay
Posts: 62
Joined: 07 Aug 2010, 18:58

Re: ODB++ Bug

#4 Post by matttay » 28 Sep 2022, 12:14

Thanks very much, Alex!

Post Reply