Need Help - Copper Pour does not work.

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
Batucada
Posts: 4
Joined: 14 Feb 2023, 10:23

Need Help - Copper Pour does not work.

#1 Post by Batucada » 20 Feb 2023, 05:59

It's not like this is my first time working with Copper Pouring. I have already used pouring on several boards, boards that are much more complex. I have loaded and checked these files to study. These files work. However, my newest file will not. I feel like I did when I first tried it years ago. Even trying with a small area as shown, presents me with an obstacle. Any ideas?
Bildschirmfoto 2023-02-20 um 17.32.01.png
Bildschirmfoto 2023-02-20 um 17.32.01.png (30.31 KiB) Viewed 399 times
ELV-RV-100-mod Endstufe.dip
(376.61 KiB) Downloaded 56 times

farley
Posts: 157
Joined: 15 Sep 2011, 09:28

Re: Need Help - Copper Pour does not work.

#2 Post by farley » 20 Feb 2023, 08:41

The board outline on the dip file is shown as a board cutout. Convert it to a board outline and the pour should work.

Batucada
Posts: 4
Joined: 14 Feb 2023, 10:23

Re: Need Help - Copper Pour does not work.

#3 Post by Batucada » 20 Feb 2023, 12:07

Hello

thank you for the answer

I would have reported earlier, right after sending the post I noticed the error. But unfortunately I could not access the post because it was still in moderation.

Post Reply