Surface pad not showing via hole?

Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
Post Reply
Message
Author
Werner
Posts: 7
Joined: 17 Jan 2012, 01:08

Surface pad not showing via hole?

#1 Post by Werner » 29 Feb 2012, 15:31

Hi Guys, I have a surface pad on the back of my board with a via in the center. The via shows up correctly on the top side of board but is coverd by the surface pad on the back? I had thought that the via would have shown that it go's all the way through the board and surface mount pad? I did connect the two to the same net with no luck?
Thanks for the help!! :D
Werner
You do not have the required permissions to view the files attached to this post.

Alex
Technical Support
Posts: 3703
Joined: 14 Jun 2010, 06:43

Re: Surface pad not showing via hole?

#2 Post by Alex » 12 Mar 2012, 08:37

There is small issue in the software. If you place a component with smd pads on already existing through via, its hole becomes invisible. We will fix the issue in next versions. Thanks.

Post Reply