Hi
This is my first attempt to make a footprint, so maby I am missing something obvious.
One of the pads is a rectangle with a hole. The hole should be adjusted towards the right side. (not placed in the middle of the pad.)
How do I achive this?
//lg
Irregularly pad
-
- Posts: 10
- Joined: 08 Oct 2015, 01:06
- Location: San Diego, CA
Re: Irregularly pad
To add a pad to a project that will share a common edge with an existing pad, you must use the same line as the common edge. To do this, you must edit the original pad to access the sketch lines.