Page 1 of 1

Irregularly pad

Posted: 19 Oct 2015, 06:18
by lg.lindstrom
Hi
This is my first attempt to make a footprint, so maby I am missing something obvious.

One of the pads is a rectangle with a hole. The hole should be adjusted towards the right side. (not placed in the middle of the pad.)

How do I achive this?

//lg

Re: Irregularly pad

Posted: 05 Nov 2015, 09:38
by roseibarry
To add a pad to a project that will share a common edge with an existing pad, you must use the same line as the common edge. To do this, you must edit the original pad to access the sketch lines.