Changing Units doesn't auto-refresh pattern window in Component Editor

Report bugs here
Post Reply
Message
Author
Tomg
Expert
Posts: 1386
Joined: 20 Jun 2015, 14:39

Changing Units doesn't auto-refresh pattern window in Component Editor

#1 Post by Tomg » 28 Oct 2019, 11:04

Component Editor
1) Set Units to inches and select/highlight the name of a pattern that shows dimensions. Notice that the dimension units displayed in the pattern window are in inches.
2) Use the hotkey combination [Shift] + U to change Units to millimeters. Notice that the dimension units displayed in the pattern window are still in inches.
3) Refresh the pattern window by either selecting/highlighting the same pattern name again, or by minimizing and then maximizing the entire Component Editor window. Notice that the dimension units displayed in the pattern window have finally changed from inches to millimeters.
cu.gif
You do not have the required permissions to view the files attached to this post.
Tom

Alex
Technical Support
Posts: 3125
Joined: 14 Jun 2010, 06:43

Re: Changing Units doesn't auto-refresh pattern window in Component Editor

#2 Post by Alex » 31 Oct 2019, 10:17

Dimension units in pattern preview on the bottom left corner are not updated automatically once you change units in Component Editor. We will consider necessity to do it. Thank you for the report.

Post Reply