Page 1 of 1

Multi part component value field error when part swapped

Posted: 11 Sep 2021, 20:43
by auto-mation-assist
When replacing a component like a OpAmp that has two circuits on a schematic and one of the component parts value fields is blank then when updating to a like component that has a information in the value filed for all its parts it updates the component value fields to the new value field information correctly. However if you now switch back to the original part that has the blank value field it retains the none blank information of the prior part that it was switched to. This can be displayed on the schematics small component information window on the upper right of the schematic. This thus has the ability to provide improper information about the actual part that is being used.