Units between DT applications

Post here your comments, suggestions and problems
Post Reply
User avatar
Posts: 593
Joined: 18 Dec 2015, 15:35

Units between DT applications

#1 Post by KevinA » 24 Dec 2019, 13:24

I had to add some patterns (everything below 0402) and discovered since moving to my new computer the Pattern editor has lost it's mind. I added mm units in PCB Editor based on using this product in metric mode NOT imperial as in Grid 2.45mm - What I end up doing is adding everything from 5mm to .005mm with all the steps between. I did add it to the PCB Layout, why didn't Pattern editor pick it up?

Technical Support
Posts: 3628
Joined: 14 Jun 2010, 06:43

Re: Units between DT applications

#2 Post by Alex » 27 Nov 2020, 03:53

Units and grids settings are specific for each machine where DipTrace installed. If you move to different computer you can edit grids using "View -> Customize Grids" in PCB Layout or Pattern Editor. In regards to units you can change them using View -> Units or Shift+U.

Post Reply