mask

Report bugs here
Post Reply
Message
Author
kivancsi4
Posts: 4
Joined: 25 May 2020, 20:18

mask

#1 Post by kivancsi4 » 24 Jan 2022, 04:21

Shown in the picture.
You do not have the required permissions to view the files attached to this post.

Alex
Technical Support
Posts: 3695
Joined: 14 Jun 2010, 06:43

Re: mask

#2 Post by Alex » 24 Jan 2022, 05:54

Thank you for the report. Could you please send board file to DipTrace support or upload on the forum for verification.

kivancsi4
Posts: 4
Joined: 25 May 2020, 20:18

Re: mask

#3 Post by kivancsi4 » 24 Jan 2022, 10:47

4.2.0.1 LinuxMint 20.x
You do not have the required permissions to view the files attached to this post.

Tomg
Expert
Posts: 1860
Joined: 20 Jun 2015, 14:39

Re: mask

#4 Post by Tomg » 25 Jan 2022, 09:27

Confirmed. DipTrace 4.2.0.1, Win10-64.
Edit: Mask and hole render properly, but the obround pad is not offset as it should be.

Another observation: For the offset obround pad to fail in the 3D Preview, it must be a classic circle shape. If its height differs from its width, the 3D Preview will render correctly.
Last edited by Tomg on 25 Jan 2022, 16:36, edited 4 times in total.
Tom

kivancsi4
Posts: 4
Joined: 25 May 2020, 20:18

Re: mask

#5 Post by kivancsi4 » 25 Jan 2022, 13:36

Thank you for checking. I hope it will be improved soon.

Alex
Technical Support
Posts: 3695
Joined: 14 Jun 2010, 06:43

Re: mask

#6 Post by Alex » 26 Jan 2022, 09:04

We already fixed the problem in source codes. To avoid the problem until the next release you can make the pad shape obround (pad width and height should be a little different).

Post Reply