Copper Pour and Ground Flood Problem

[owkmann]

Hello,

I created a pattern for the TLF-50, a 2.4mm RF Vertical Launch connector.

When I flood the Top Layer and assign the pour to Ground, the Ground pad on the connector does not get flooded over.

I would like the flood to include the connector's Ground pad. How would I do this?

See the attached screen capture, showing a gap between the copper pour and the pad.

Thanks for your help,

Steve

Copper Flood.PNG (29.85 KiB) Viewed 17069 times

[Alex]

The pad and the copper pour should be connected the the same net. If the pad has already connected to GND net, please open copper pour properties and verify which net it is connected to.

[owkmann]

Thanks, yes, I verified that the copper pour is assigned to the same GND net.

[owkmann]

Problem fixed. The pattern was incorrect; sorry about that!