copper pour boundary at pad

[lclore]

Not sure what setting to adjust to work this error out. same error 6 times because layouts same.
copper pour radius around the pad violates distance to next pad.
image is with copper pour on and off. If change of state to unpoured, error goes away.
setting clearances does not adjust it out.

copper pour visible, rounded edge impedes distance to next pad

dt01.png (46.8 KiB) Viewed 3163 times

copper pour objects not enabled. trace to pad doesn't violate distance to next pad

dt02.png (49.63 KiB) Viewed 3163 times

[tgoodson]

Check the properties on the pour for the line width and spacing. I suspect that you have these set to too large a value. For starters, try reducing them by half or the minimum trace width, whichever is larger.

[lclore]

thanks- that amplified the error though.

pours on

dt03.png (70.86 KiB) Viewed 3076 times

[Serg]

Please check the setting “Copper Pour Properties → Pouring → Use Net Clearances”.