No connects
No connects
Is there a way of marking non-used or no-connect pins so that you don't get an error when running the design rule check?
Re: No connects
Hi,
Please open "Verification/ Electrical Rule Setup" from main menu in Schematic. Unselect "Not Connected" option from list of rules. After that, you won't get ERC errors if there are non-used or non-connected pins in your schematic.
Please open "Verification/ Electrical Rule Setup" from main menu in Schematic. Unselect "Not Connected" option from list of rules. After that, you won't get ERC errors if there are non-used or non-connected pins in your schematic.
Re: No connects
Yes, this will work but it will also obscure real errors and that makes the error check close to worthless.
Re: No connects
Well, don't unselect this option in that case. You can right click on pins in schematic and set "Not Connected" option for them.