Same Net Clearances (SMD to Drill)

Post your feature requests here. Please use search function to ensure it is not here yet.
Post Reply
Message
Author
Zippi
Posts: 9
Joined: 19 Jun 2010, 16:56

Same Net Clearances (SMD to Drill)

#1 Post by Zippi » 05 Sep 2019, 17:22

Hi,

can you add to the Same Net Clearance Feature the Clearances between SMD and Drill (only a manuall drill and the drill from an via).

This make it possible to place a masked closed via with the half ring over a pad.

best regards,
Zippi

d1wang
Posts: 46
Joined: 13 Nov 2018, 02:19

Re: Same Net Clearances (SMD to Drill)

#2 Post by d1wang » 20 Sep 2019, 07:55

You are probably asking for trouble by placing a via very close to a pad. I use 0.3mm vias, which are pretty small (if I go smaller, the fab house will charge extra), and half the time the vias aren't closed.

Post Reply