I have existing PCB designed/verified/made in older version of DipTrace (not sure the version that was created with). I am modifying the design to accommodate new requirement. However, after I run Autorouter I am getting several messages in regards to copper pour such as:
Drill - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Via_336 - Copper Pour (Gap=-0.395mm, Rule=0.152mm)
Pretty much I cannot add any new Via's without these errors showing up.
What can be done to resolve these?
Making PCB Layouts, Manual routing, Auto-routing, Copper pouring, Updating from Schematic, Manufacturing Output
2 posts • Page 1 of 1