$0.45 Servo Tester Board

"How-to" questions from new engineers and designers. Please ask and respond here.
Post Reply
Mike Dong
Posts: 18
Joined: 06 Nov 2018, 02:27

$0.45 Servo Tester Board

#1 Post by Mike Dong » 24 May 2020, 22:13

Create a very cheap and effective board for testing a servo using minimal parts. This uses a 555 timer and is sponsored by PCBgogo.com.
Things used in this project
Hardware components

  • 555 Timer SOP-8
  • 0805 Resistor 1k
  • 0805 Resistor 4.7k
  • 0805 Resistor 10k
  • 0805 Resistor 33k
  • 0805 Resistor 68k
  • 0805 Capacitor 10nF
  • 0805 Capacitor 100nF
  • 6x6x8mm SMD Pushbutton
  • TO92 NPN Transistor
Software apps and online services
  • Eagle
  • Autodesk Fusion 360
  • PCBGogo.com
Hand tools and fabrication machines
  • Soldering iron (generic)
  • 3D Printer (generic)
A while back I had the idea to create a device that could quickly determine the direction of servos and/or whether they even work correctly. It would need to be small and portable, along with being inexpensive.


I went searching for a way to control a servo without the need for a microcontroller, and I found it on 555-timer-circuits.com. They had a design for a circuit that could turn a servo in either direction with minimal components. It utilized a 555 timer, which is cheap and reliable.
Designing the PCB
Creating the board layout wasn’t too difficult. I started by laying down the 555 timer and pin headers, then I added the supporting components and buttons.
Creating the PCB
Now that everything was laid out, I had to create a gerber file for it to be fabricated. The first and only step is to click the “CAM Processor” at the top and select the oshpark-2-layer.cam job file and then process it.

Then I went to PCBgogo.com and loaded their gerber file viewer to ensure I had created the files correctly.

With most PCBs, a stencil is highly recommended to ensure even and accurate coverage of solder paste.

They sent me a stainless-steel stencil that had cutouts for each pad. I began by covering the edge of a putty knife with solder paste, and then I ran it over the stencil twice: once at 45 degrees and then once at 70 degrees.

This creates a nice application of solder paste without much waste. Lastly, I placed each component with tweezers, placing the smallest components first, such as resistors and capacitors.

This prevents having to reach over large or tall parts and possibly bumping them. I reflowed the boards in a cheap toaster oven at about 300 degrees Fahrenheit.


Using the device is simple. All that is needed is to plug in a 5v power source and servo motor, then pressing either button to move it.

I also designed a 3D-printable case for it that hides the board and only exposes the necessary areas.
You do not have the required permissions to view the files attached to this post.

Post Reply